Cart

Your Cart is Empty

Back To Shop

Cart

Your Cart is Empty

Back To Shop
Sale

APC Power-Saving Back-UPS Pro 700 (120V)

Original price was: $420.99.Current price is: $99.00.

(In Stock)

SKU: VC84643811149 Category:
  • Output: 420W/700VA
  • Input: 120V
  • 3x Battery Backup, 3x Surge Protection
  • NEMA 5-15R
  • Recharge Time: 12 Hours
  • Audio Alarms
  • RJ-45 Connector
  • LCD Status and Control Console
  • Cold Start/Hot Swappable Batteries

The Power-Saving Back-UPS Pro 700 (120V) from APC provides power to your important computer components in the event of an electrical outage. The Uninterruptible Power Supply (UPS) contains a battery which continues to power computers, monitors and other components if the electricity is cut from them. An LCD status display provides information including remaining battery life, load capacity, and event notices. The battery is hot-swappable and easy to replace. An audible alarm alerts you of events like power outage and low battery.

Battery and Surge Protected Outlets Back up and protect your hardware and data during power outages, surges and spikes. DataLine Surge Protection Provides protection of connected equipment from power surges on the data lines. Surge Only Outlets Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage. Energy Management Function Energy saving feature automatically power off peripherals when the a master device, usually a PC, hibernates or is shut down. Power to peripherals is immediately restored when the master device wakes up or is switched on. Boost and Trim Automatic Voltage Regulation (AVR) Gives higher application availability by correcting low and high voltage conditions without using the battery. Green Mode Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection. Customizable Voltage-Transfer Points Adjust the voltage points (widen or tighten the range) where your UPS transfers to battery to maximize useful battery life and protect sensitive electronics. Customizable Voltage Sensitivity Toggle between pre-determined voltage-transfer points depending on your power quality (high, medium or low sensitivity), maximizing useful battery life and protecting sensitive electronics. Intelligent Battery Management Maximizes battery performance, life, and reliability through intelligent, precision charging. Cold-Start Capable Provides temporary battery power when the utility power is out. Battery Failure Notification Provides early-warning fault analysis on batteries enabling timely preventive maintenance. Automatic Self-Test Periodic battery self-test ensures early detection of a battery that needs to be replaced. Transformer-Block Spaced Outlets Protect equipment with input transformer blocks without blocking access to other receptacles. Resettable Circuit Breaker Easy recovery from overloads; no need to replace a fuse. Simple Battery Replacement Increases UPS availability by allowing quick, easy battery replacement. USB Connection Use your PC to access additional power protection and management features for your UPS via a USB Port. LCD Status Display Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs. Audible Alarms Provides notification of changing utility power and UPS power conditions Disconnected Battery Notification Warns when a battery is not available to provide backup power. UPC: 731304266792

Output Output Power Capacity: 420 Watts/700 VA
Nominal Output Voltage: 120V
Efficiency at Full Load: 87.0%
Output Frequency (sync to mains): 50/60 Hz +/- 3 Hz user adjustable +/- 0.1
Waveform Type: Stepped approximation to a sinewave
Output Connections:
3 x NEMA 5-15R / Battery Backup
3 x NEMA 5-15R / Surge Protection
Input Nominal Input Voltage: 120V
Input Frequency: 50/60 Hz +/- 3 Hz (auto sensing)
Input Connections: NEMA 5-15P
Cord Length: 6 feet / 1.83 meters
Input Voltage Range for Main Operation: 93 – 130 V

Maximum Input Current: 12 A
Input Breaker Capacity: 15 A

Battery Typical Recharge Time: 12 hours
Replacement Battery: RBC17
Included Battery Modules: 1
Communications Interface Ports: USB
Surge Protection and Filtering Surge Energy Rating: 354 Joules
Filtering: Full time multi-pole noise filtering, 5% of IEEE surge let-through, zero clamping response time instantaneous
Data Line Protection: Network line – 10/100/1000 Base-T Ethernet (RJ-45 connector), Coaxial cable for CATV/SATV/modem/Audio-Video (coax connector)
Conformance Regulatory Approvals: FCC Part 15 Class B,NOM,TUV,UL 1778
Environmental Compliance: RoHS,REACH: Contains No SVHCs
Environmental Requirements Operating Temperature: 32 – 104F / 0 – 40C
Storage Temperature: 23 – 113F / -15 – 45C
Humidity: 0-95%
Operating Elevation: Up to 10,000′ / 3000 m
Storage Elevation: Up to 50,000′ / 15,000 m
Protection Equipment protection policy Lifetime : $150000
Dimensions (HxWxD) 7.48 x 3.58 x 12.20″ / 190 x 91 x 310 mm
Weight 15.73 lb / 7.15 kg
Packaging Info
Package Weight 17.5 lb
Box Dimensions (LxWxH) 17.2 x 9.9 x 5.6″

In the Box APC Power-Saving Back-UPS Pro 700 (120V)

  • CD with Software
  • USB Cable
  • User Manual
  • 3-Year Repair or Replace Warranty

All product and company names are trademarks or registered trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.

Reviews

There are no reviews yet.

Be the first to review “APC Power-Saving Back-UPS Pro 700 (120V)”

Your email address will not be published. Required fields are marked *

Cart

Your Cart is Empty

Back To Shop